Template: M.2 TO 4G/5G HAT资源简介
From Waveshare Wiki
What's On Board
| Number | Name | Description |
|---|---|---|
| ① | Raspberry Pi GPIO Header | Easily connect to Raspberry Pi |
| ② | Switch | Enable the corresponding pin |
| ③ | M.2 Interface | Compatible with RM500U-CN / RM500Q-CN / RM500Q-GL /RM50XQ-AE and other series of 5G modules |
| ④ | SIM Card Holder | Onboard two SIM card slots, dual card single standby. The default SIM1 card slot works, SIM2 is on the back, requires module support and must be switched through AT commands |
| ⑤ | USB 3.1 Connector | Backward compatible with USB 2.0, can be used to connect to PC/Raspberry Pi/Jetson Nano, etc. |
| ⑥ | USB Type-C Connector | 5V 3A input; stable and flexible power supply |
| ⑦ | Audio Port | SIM82XX series support audio function, RM50XX series do not support this audio function |
| ⑧ | Antenna Connector | Onboard four-way antenna, strong signal |
| ⑨ | Reset Switch | One-key reset |
| ⑩ | Power Switch | To facilitate the power supply mode of the control module:
——If set to USB, the module will provide power through the "⑤.USB3.1 interface"; |
| ⑪ | Cooling Fan | Cool down the Raspberry Pi and 5G module at the same time |
| ⑫ | Indicator | Check the module running status anytime, anywhere |
| Number | Name | Description |
|---|---|---|
| ⑬ | Cooling Fan | Simultaneously cooling Raspberry Pi and 5G modules |
| ⑭ | SIM Card Slot 2 | Switchable via AT command (module is required) |
| ⑮ | Module Setting Switch | Switch A to ON for SIM7600X / A7906X / IM7906X / SIM7912X series 4G M.2 module; Switch B to ON, for SIM8202X / SIM8200EA / SIM8262X series 5G M.2 module; Switch C to ON, for RM50X / RM520N-GL / EM06X series 5G / LTE-A M.2 module |
| ⑯ | USB Interface Pad | USB 2.0 interface pad |
| ⑰ | NAU8810X Audio Chip | For SIMN7600X / SIM8XXX series module, does support RM5XX and EM06XX series module |
| ⑱ | Fan Header | 5V power supply for cooling fan |