Template: Jetbot ai kit Faq

From Waveshare Wiki
Jump to: navigation, search

FAQ

 Answer:
Three 18650 batteries are used and the voltage of every battery is 3.7V. Generally, the voltage per battery is 4.2V when full charging. Please use batteries without a protective plate.

BTW, Power of JetBot is down when the voltage of the whole system is similar to 9V (it is not accurate), we recommend you to charge batteries if the voltage displayed is lower than 10V.
We recommend you to use high-quality batteries like Sanyo or Panasonic.
Batteries 18650 en.jpg

{{{4}}}

{{{5}}}


 Answer:
When the motor rotates in the wrong direction, check whether the motor wires are reversed.
{{{4}}}

{{{5}}}


 Answer:
The 12.6V power supply cannot directly supply power to the Jetson Nano. It is used to plug into the 12.6V port on the expansion board, charge the battery, and then power the Jetson Nano from the battery. Please do not directly connect to Jetson Nano. If you need to buy a Jetson nano power supply, you can click here to get it.
{{{4}}}

{{{5}}}


 Answer:
The charging indicator is on the charger, the green light is full, and the red light is charging.
{{{4}}}

{{{5}}}


 Answer:
The account and password of the JetBot system are jetbot.
{{{4}}}

{{{5}}}


 Answer:
The Linux system does not display the input content when entering the password. Please enter jetbot directly on the keyboard and press Enter.
{{{4}}}

{{{5}}}


 Answer:
If you are installing the battery for the first time, or have disassembled the battery before, please note that you need to connect the distributed power supply to charge the car for a few seconds, and then turn on the protection circuit before it can be used normally.
{{{4}}}

{{{5}}}


 Answer:
Due to the partition problem, the TF card with the image of the Jetson Nano programmed cannot recognize the drive letter normally on the Windows computer. If you need to reformat it, search for Disk Management in the search bar of windows and open the Disk Management interface. Find the removable disk where the TF card is located (be careful not to mistake it for another disk), right-click and select Delete Volume, then create a new volume and format it by default. After the default format, the drive letter of TF will be recognized again. At this time, the space and memory of the TF card are incorrect. Note that you need to use the formatting software to quickly format the new drive letter again. After formatting, if the memory space of the TF card is normal, the new image can be re-programmed normally.
{{{4}}}

{{{5}}}


 Answer:
The 12V power adapter is used to charge the batteries. DO NOT directly connect it to Jetson Nano Developer board.
{{{4}}}

{{{5}}}


 Answer:
Please make sure that you have installed the codes of Waveshare instead of NVIDIA's. The drive codes of the motor are different between Waveshare's and NVIDIA's. If you have updated the one from NVIDIA's, please remove the Jetbot folder and download ours by following step 5.
{{{4}}}

{{{5}}}