Raspberry Pi Zero WH Package F
| ||
Instroduction
The Raspberry Pi Zero is half the size of a Model A+, with twice the utility. A tiny Raspberry Pi that’s affordable enough for any project!
Note: this is the original Pi Zero V1.3, for the new version with built-in WiFi, please check
- Difference among Zero, Zero W, and the Zero WH
The Raspberry Pi Zero is the basic version of the Raspberry Pi Zero series without WiFi and Bluetooth functions. The Raspberry Pi WH has a wireless card featuring WiFI and Bluetooth functions. The Raspberry Pi Zero WH version has a pre-soldered 40PIN pin-header based on the Raspberry Pi W for easy use.
Raspberry Pi Features
- Broadcom BCM2835
- 1GHz ARM11 single-core processor
- 512MB RAM
- Micro SD card slot
- Mini-HDMI port (1080p60 video output)
- Micro-USB power
- Micro-USB OTG port
- 40PIN unpopulated GPIO header (compatible with A+/B+/2B/3B)
- CSI camera connector
- Composite video header
- Composite reset header
- Dimension: 65mm x 30mm x 5mm
Raspberry Pi Zero vs Raspberry Pi W
The Raspberry Pi W has a wireless card, which supports WiFi and Bluetooth.
1.3inch LCD HAT
Features
- Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards
- IPS screen, wide viewing angle, better display
- High definition in small size
- 1x joystick, 3x pushbuttons, handy and useful
Specification
- Driver: ST7789
- Interface: SPI
- Display color: RGB, 65K color
- Resolution: 240x240
- Backlight: LED
- Operating voltage: 3.3V
For more information about the 1.3inch LCD HAT, please refer to the wiki of the 1.3inch LCD HAT
UPS HAT (C)
Features
- Onboard spring pogo pins for connecting with Raspberry Pi Zero series boards
- Li-po battery recharge chip, with dynamic path management, more stable power supply
- Voltage boost chip, providing regulated 5V power output
- I2C bus communication, monitoring the battery voltage, current, power, and remaining capacity in real time
- Multi battery protection circuits: over charge/discharge protection, over current protection, and short circuit protection, more safe and stable
- Recharging indicator for monitoring the battery operating status
- Comes with development resources and manual
Specifications
- Output voltage:5V
- Charger:5V
- Control bus:I2C
- Battery supported:803040 Li-po battery 1000mAh 3.7V
- Dimensions:65 × 30mm
- Mounting hole:3.0mm
For more information about the UPS HAT (C), please refer to the wiki of the UPS HAT (C)
General Tutorial Series
- Raspberry Pi Tutorial Series
- Raspberry Pi Tutorial Series: Access your Pi
- Raspberry Pi Tutorial Series: Getting Started with lighting up an LED
- Raspberry Pi Tutorial Series: External Button
- Raspberry Pi Tutorial Series: I2C
- Raspberry Pi Tutorial Series: I2C Programming
- Raspberry Pi Tutorial Series: 1-Wire DS18B20 Sensor
- Raspberry Pi Tutorial Series: Infrared Remote Control
- Raspberry Pi Tutorial Series: RTC
- Raspberry Pi Tutorial Series: PCF8591 AD/DA
- Raspberry Pi Tutorial Series: SPI
Resources
Documents
- Raspberry Pi W Schematic
- Raspberry Pi V1.3 Schematic
- BCM2835 Datasheet]
- Raspberry Pi Drawing
- Raspberry Pi link