3.2 Manual Firmware Upgrade
Note: Manual Firmware Upgrade is required only if the General Firmware Upgrade doesn't work.
Procedure for manually upgrading the JTAGICE XPII Firmware:
- Disconnect the JTAGICE XPII from the power or just turn off the power switch
- Short the hole 3 and hole 9 (as shown in the figure below)
- Provide hole 4 (VCC) and hole 10 (GND) a level of 3V-5.5V
- Connect the JTAGICE XPII to the host PC through USB or RS-232 cable
- Power the JTAGICE XPII and wait for 3 seconds
- Start General Firmware Upgrade
|