Difference between revisions of "Template:RPi LCD FAQ"

Configure your Pi:

sudo raspi-config

• Select Expand Filesystem.
• You should make sure the custom mirror image used can boot to desktop. Check the configuration: Enable Boot to Desktop/Scratch -> Desktop Log in as user 'pi' at the graphical desktop

Download LCD-show-YYMMDD.tar.gz and extract it. Copy the file LCD-show.tar.gz into your custom mirror image via the network or an U disk. Run the following commands:

tar xvf LCD-show.tar.gz
cd LCD-show/

• For 3.2inch RPi LCD (B), run the command:

sudo ./LCD32-show

• For 3.5inch RPi LCD (A), run the command:

sudo ./LCD35-show

• For 4inch RPi LCD (A), run the command:

sudo ./LCD4-show

• For 5inch HDMI LCD, run the command:

sudo ./LCD5-show

Then, wait a few minutes, the system will restart automatically. When finished, the RPi LCD is ready to use.

To switch to HDMI display, run the command:

sudo ./LCD-hdmi

You should update the mirror image in the same manner as the method shown below, otherwise the system mirror image may not run after updated:

sudo apt-mark hold raspberrypi-bootloader
sudo apt-get update
sudo apt-get upgrade