Template: Pico-BLE Guide
Get Started Quickly with Pico
Firmware Download
PICO series1——introduction
PICO series2—— peripheral GPIO
PICO series3——PWM
PICO series4——ADC
PICO series5——UART
PICO series6——I2C
PICO series7——SPI
Software Setup
If you are the first time o use the Pico, you need to first learn how to get started at the Pico before you run other examples.
The Pico supports C and the Micropython which requires different firmware.
In most of the examples archives (Demo codes), we provide a Micropython firmware (uf2 file), we recommend you to use the provided firmware to test the board. Because the codes may run abnormally with different firmware.
If the board is tested to be workable, you can also download the newest firmware from Raspberry Pi and do further programming.
- If you want to use C codes, please refer to the C/C++ Guides
- If you want to use Micropython codes, please refer to the Micropython Guides.
- The link of the newest Micropython firmware of Pico
- Official Guides of Raspberry Pi Pico
Examples
For the Pico-BLE module, we provide an serial example. Hereby we take C codes to explain the function.
Low-level hardware interface
BLE.c
The Bluetooth module initialization function mainly judges whether the Bluetooth module is successfully connected to the mobile phone, whether the notify function is enabled, querying the baud rate of the Bluetooth module, judges whether it is in low power mode, name, address, and modifying the name of the module
void BLE_Init()
Execute and process BLE commands
uint8_t Cmd_Process(uint8_t *data)
data: the address of the command pointer to send
Transparent transmission receiving function, what data the mobile phone sends to the module, the module receives and returns the same data through this function
void UART_RX() Query receive void UART_RX_IRQ() Interrupt receive
Parameter modification
BLE.h
#define UART_ID uart0 Pico serial port selection #define BAUD_RATE 115200 Serial port baud rate selection #define DATA_BITS 8 Serial port data bits #define STOP_BITS 1 Serial port data stop bits #define PARITY UART_PARITY_NONE Whether the serial port performs parity check #define UART_TX_PIN 0 Pico serial port TX pin selection #define UART_RX_PIN 1 Pico serial port RX pin selection #define BLE_MODE_PIN 15 Bluetooth module status detection pin
Module command
CMD.h
For specific use, please refer to the user manual.