Difference between revisions of "Template:MQ-2 Gas Sensor Spec"
From Waveshare Wiki
| Line 9: | Line 9: | ||
*Signal output indicator | *Signal output indicator | ||
==Specification== | ==Specification== | ||
| + | *Boost chip: PT1301 | ||
*Power: 2.5V ~ 5.0V | *Power: 2.5V ~ 5.0V | ||
*Dimension: 40.0mm * 21.0mm | *Dimension: 40.0mm * 21.0mm | ||
*Mounting holes size: 2.0mm | *Mounting holes size: 2.0mm | ||
| + | |||
==Pinouts== | ==Pinouts== | ||
{|class="wikitable" | {|class="wikitable" | ||
Latest revision as of 06:35, 20 July 2022
Overview
The gas sensing material used in the MQ-2 gas sensor is tin dioxide (SnO2), which has low conductivity in clean air. When there is flammable gas in the environment where the sensor is located, the conductivity of the sensor increases with the increase of the flammable gas concentration in the air. The MQ-2 gas sensor has a high sensitivity to liquefied gas, propane, and hydrogen, and is also ideal for the detection of natural gas and other combustible vapors. This sensor can detect a variety of flammable gases and is a low-cost sensor suitable for a variety of applications.
Features
- Sensitive for LPG, propane, hydrogen
- Output voltage boosts along with the concentration of the measured gases increases
- Fast response and recovery
- Features boost circuit
- Adjustable sensitivity
- Signal output indicator
Specification
- Boost chip: PT1301
- Power: 2.5V ~ 5.0V
- Dimension: 40.0mm * 21.0mm
- Mounting holes size: 2.0mm
Pinouts
| PIN | Description |
| DOUT | Digital data output |
| AOUT | Analog data output |
| GND | Ground |
| VCC | Power input (2.5V~5.0V) |