Difference between revisions of "Template:L76K GPS Module Spec"
From Waveshare Wiki
Line 7: | Line 7: | ||
{|style="width:700px;"class="wikitable" align="center" | {|style="width:700px;"class="wikitable" align="center" | ||
|- align="center" | |- align="center" | ||
− | !Interface!!Description | + | !Interface!! Description |
|-align="center" | |-align="center" | ||
|VCC||Power supply (2.7V~5V) | |VCC||Power supply (2.7V~5V) | ||
Line 19: | Line 19: | ||
|PPS||Status indication (output second pulse if the positioning is successful) | |PPS||Status indication (output second pulse if the positioning is successful) | ||
|} | |} | ||
+ | ==NMEA0183== | ||
+ | *The host control output NMEA0183 information from the serial port, and analyze NMEA 0183 sentence to output the information. |
Revision as of 06:48, 2 December 2022
Overview
Introduction
L76K is a multi-satellite system (GPS, BeiDou, GLONASS, QZSS), multi-system joint positioning and single system independent positioning, supports AGNSS function, built-in low noise amplifier and surface acoustic filter, can provide users with fast and accurate, GNSS module with high-performance positioning experience.
This module supports Raspberry Pi, STM32, Arduino, Raspberry Pi Pico and ESP32 control demo.
Parameters
Interface
Interface | Description |
---|---|
VCC | Power supply (2.7V~5V) |
GND | Ground |
TX | UART data output |
RX | UART command input |
PPS | Status indication (output second pulse if the positioning is successful) |
NMEA0183
- The host control output NMEA0183 information from the serial port, and analyze NMEA 0183 sentence to output the information.