|
|
| Line 1: |
Line 1: |
| − | ==Hardware connection==
| |
| − | *Raw panel + ESP8266 Driver Board
| |
| − | : If you have the ESP8266 e-Paper Driver board as well as an e-Paper raw panel. You can just connect the e-paper panel to the ESP8266 board
| |
| − | : Configure the switch according to the type of display
| |
| − | :[[File:Epd esp8266 hardware 1.png|400px]]
| |
| − | {|class="wikitable"
| |
| − | !Trigger state!!e-Paper
| |
| − | |-
| |
| − | |A||1.54inch e-Paper, 2.13inch e-Paper, 2.13inch e-Paper (D), 2.9inch e-Paper
| |
| − | |-
| |
| − | |B||1.54inch e-Paper (B), 1.54inch e-Paper (C)
| |
| − | 2.13inch e-Paper (B), 2.13inch e-Paper (C)<br/>
| |
| − | 2.7inch e-Paper (B)<br />
| |
| − | 2.9inch e-Paper (C), 2.9inch e-Paper (B)<br />
| |
| − | 4.2inch e-Paper (B), 4.2inch e-Paper (C)<br >
| |
| − | 5.83inch e-Paper (B), 5.83inch e-Paper (C) <br />
| |
| − | 7.5inch e-Paper (B), 7.5inch e-Paper (C), 7.5inch HD e-Paper, 7.5inch HD e-Paper (B)<br />
| |
| − | |}
| |
| − | '''Note: The ACeP e-Paper doesn't support this connecting method.'''
| |
| − | *e-Paper Module/HAT + ESP8266 Board
| |
| − | : If you have the ESP8266 Board as well as the e-Paper module/HAT which has PCB already, you can wire the displays by 8-pin cable pin
| |
| − | {|border=1; style="width:700px;" align="center"
| |
| − | |+ Connect to ESP8266 Driver Board
| |
| − | |-style="background:#2D6FDF; color:white;" align="center"
| |
| − | |e-Paper||ESP8266
| |
| − | |-align="center"
| |
| − | |Vcc||3.3V
| |
| − | |-align="center"
| |
| − | |GND||GND
| |
| − | |-align="center"
| |
| − | |DIN||GPIO13
| |
| − | |-align="center"
| |
| − | |CLK||GPIO14
| |
| − | |-align="center"
| |
| − | |CS||GPIO15
| |
| − | |-align="center"
| |
| − | |DC||GPIO4
| |
| − | |-align="center"
| |
| − | |RST||GPIO2
| |
| − | |-align="center"
| |
| − | |BUSY||GPIO5
| |
| − | |}
| |
| | ==Run the Demo Codes== | | ==Run the Demo Codes== |
| | *Open the Arduino IDE | | *Open the Arduino IDE |
