Difference between revisions of "Template:5.83inch e-Paper HAT (B) sunrise"
From Waveshare Wiki
(Created page with " =Working With Sunrise X3 Pi= ==Hardware Connection== When connecting the Sunrise X3 Pi, you can directly insert the board into the 40PIN pin header of the Sunrise X3 Pi, and...") |
m (Text replacement - "https://www.waveshare.com/w/upload/" to "https://files.waveshare.com/upload/") |
||
| Line 54: | Line 54: | ||
<pre> | <pre> | ||
sudo apt-get install p7zip-full | sudo apt-get install p7zip-full | ||
| − | wget https:// | + | wget https://files.waveshare.com/upload/3/39/E-Paper_code.7z |
7z x E-Paper_code.7z -O./e-Paper | 7z x E-Paper_code.7z -O./e-Paper | ||
cd e-Paper/RaspberryPi_JetsonNano/ | cd e-Paper/RaspberryPi_JetsonNano/ | ||
Revision as of 06:17, 2 September 2023
Working With Sunrise X3 Pi
Hardware Connection
When connecting the Sunrise X3 Pi, you can directly insert the board into the 40PIN pin header of the Sunrise X3 Pi, and pay attention to the correct pins.
If you choose to connect with an 8PIN cable, please refer to the pin correspondence table below:
| e-Paper | Sunrise X3 Pi | |
| BCM | Board | |
| VCC | 3.3V | 3.3V |
| GND | GND | GND |
| DIN | MOSI | 19 |
| CLK | SCLK | 23 |
| CS | CE0 | 24 |
| DC | 25 | 22 |
| RST | 17 | 11 |
| BUSY | 24 | 18 |
Enable SPI
- SPI is enabled by default. If you have disabled it, you can enable it by following the steps below.
- Enter the command: sudo srpi-config
Python
- The corresponding library has been installed in the function. If you uninstall it accidentally, please use the following command to install it.
sudo apt-get update sudo apt-get install python-pip sudo apt-get install python-pil sudo apt-get install python-numpy sudo pip install Hobot.GPIO sudo pip install spidev
- Download the demo via GitHub (skip this step if you have downloaded it).
git clone https://github.com/waveshare/e-Paper.git cd e-Paper/RaspberryPi_JetsonNano/
- Download the demo (skip this step if you have downloaded it).
sudo apt-get install p7zip-full wget https://files.waveshare.com/upload/3/39/E-Paper_code.7z 7z x E-Paper_code.7z -O./e-Paper cd e-Paper/RaspberryPi_JetsonNano/
- Run the demo
# Make sure you are in e-Paper/RaspberryPi_JetsonNano/ cd python/examples/ python3 epd_5in83b_V2_test.py