TTL TO RS422 (B)
From Waveshare Wiki
| ||
| ||
Overview
TTL TO RS422 (B) is an industrial-grade rail-mounted electrically isolated TTL-to-RS485 serial converter.
Feature
- Compatible with TTL/RS485 standard, converting the TTL signal into a balanced differential RS485 signal, supporting full-duplex communication.
- Compatible with 3.3V ~ 5V TTL signal level, with anti-reverse connection and anti-over-voltage circuit on the power supply side.
- Onboard unibody power supply isolation, provides stable isolated voltage and needs no extra power supply for the isolated terminal.
- Onboard unibody digital isolation, allows signal isolation, high reliability, strong anti-interference, and low power consumption.
- Onboard TVS (Transient Voltage Suppressor), effectively suppresses surge voltage and transient spike voltage in the circuit and is anti-electrostatic.
- Onboard resettable fuse and protection diodes, ensure the current/voltage stable outputs, provide over-current/over-voltage protection, and improve shock resistance.
- On-board RS485 input and output 120R resistors with built-in jumper caps for switching enable.
- Industrial rail-mount ABS case design, small in size, easy to install, and cost-effective.
Parameters
Model | Galvanic isolated TTL to RS422 converter | |
---|---|---|
Power Port | Power Supply | 3.3V ~ 5V |
Interface Protection | anti-over-discharge, reverse-proof | |
Device Interface | Compatible with TTL / RS485 standard | |
TTL Interface | Interface Type | Screw terminal |
Transmission Distance | less than 10m | |
Transmission Model | Point to point | |
RS422 Interface | Interface type | Screw terminal |
Interface Protection | Provide 600W lightningproof, surge-suppress and 15KV ESD protection | |
Terminal Resistance | 120R, enabled/disabled via jumper (inside the case) | |
Transmission Distance | About 1200m | |
Transmission Mode | Point-to-multipoint (Up to 32 nodes can be connected, and relays are recommended for more than 16 nodes) | |
Product Appearance | Case | Rail-mount ABS case, suitable for 35mm DIN rail |
Dimensions | 91.6 × 58.7 × 23.3mm |
Basic Function
Convert TTL signal to balanced differential RS422 signal, which can be used for interface conversion, and node expansion, and can also be used to extend the communication distance.
Interface Introduction
* Note: the TTL TO RS422 (B) is designed to be used with RS422 devices, however, it is also possible to be used with RS485 devices (yet only sending is available). It is recommended to use TTL TO RS485 (B).