*ILI9341 has the following data interface modes:
1) i80-system MPU port (8-/9-/16-/18-bit bus width).<br/>
3 KB (462 words) - 06:15, 2 September 2023
|interface1=RPI USB\SPI\I80
...T for Raspberry Pi, 1600 × 1200 resolution, 16 grayscales, USB/SPI/I80/I2C interface.
18 KB (2,643 words) - 01:07, 29 January 2024
...is not recommended at present, it is recommended to use a USB, I80, or SPI interface.<br/>
Whether it is driven by a USB interface, I80 interface, or SPI interface, it is necessary to turn the DIP switch circled in the red frame in the fig
18 KB (2,563 words) - 09:40, 20 March 2024
...r HAT uses IT8951 as a controller, it can be controlled by USB/SPI/I80/I2C interface with the resolution of 1448 × 1072, 6inch EPD (Electronic Paper Display) d
*Its design is based on the Raspberry Pi 40PIN GPIO interface, suitable for the Raspberry Pi series.
21 KB (3,116 words) - 06:23, 30 January 2024
|interface2=I80
...T for Raspberry Pi, 1872 x 1404 resolution, 16 gray scale, USB/SPI/I80/I2C interface
22 KB (3,203 words) - 09:36, 20 March 2024
|caption2=800x600, 6inch EPD HAT for Raspberry Pi, USB/SPI/I80/I2C interface
|interface2=I80
31 KB (4,679 words) - 07:58, 13 December 2023
|caption2=1872 × 1404, 10.3inch EPD HAT for Raspberry Pi, USB/SPI/I80/I2C interface
|interface2=I80
36 KB (5,233 words) - 08:43, 30 January 2024
|caption2=1200 × 825, 9.7inch EPD HAT for Raspberry Pi, USB/SPI/I80/I2C interface
|interface2=I80
30 KB (4,533 words) - 03:36, 24 January 2024
|caption2=1872 × 1404, 7.8inch EPD HAT for Raspberry Pi, USB/SPI/I80/I2C interface
|interface2=I80
36 KB (5,576 words) - 03:49, 24 January 2024
