Raspberry Pi networked via RNDIS
From Waveshare Wiki
The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.
- Execute the following commands to check whether ttyUSB2 can be recognized normally, if it is successfully recognized, open the port through minicom
ls /dev/ttyUSB* sudo minicom -D /dev/ttyUSB2
- Send the following commands through minicom and wait for the module to restart
AT+CUSBPIDSWITCH=9011,1,1
- Run the ifconfig command to see if a USB0 card is identified
ifconfig
- Get IP address
sudo dhclient -v usb0
Note: If you need to switch to the windows system to use, or restore to the default settings of the module, you can send the following command:
AT+CUSBPIDSWITCH=9001,1,1