Raspberry Pi networked via RNDIS

• Execute the following commands to check whether ttyUSB2 can be recognized normally, if it is successfully recognized, open the port through minicom

ls /dev/ttyUSB*
sudo minicom -D /dev/ttyUSB2

• Send the following commands through minicom and wait for the module to restart

AT+CUSBPIDSWITCH=9011,1,1

• Run the ifconfig command to see if a USB0 card is identified

ifconfig

• Get IP address

sudo dhclient -v usb0

Note: If you need to switch to the windows system to use, or restore to the default settings of the module, you can send the following command:

AT+CUSBPIDSWITCH=9001,1,1

More ways to dial

SIM7600X ECM dial-up Internet