RS232 Board

RS232 Board RS232 communication board, SP3232 on board, 3V-5.5V, ESD enhanced, hardware flow control supported

{{{name2}}}

{{{name3}}}

{{{name4}}}

{{{name5}}}

Primary Attribute Category: Modules, RS232/RS485/CAN {{{userDefinedInfo}}}: {{{userdefinedvalue}}} Brand: Waveshare

Website International: Website Chinese: 官网

Onboard Interfaces UART

Related Products 2-CH RS485 HAT 2-CH RS232 HAT 2-CH CAN FD HAT 2-CH CAN HAT Modbus RTU Relay RS232 Board RS232 TO RS485 RS485 Board (3.3V) RS485 Board (5V) SN65HVD230 CAN Board USB TO RS485 USB TO RS232/485/TTL

Introduction

RS232 communication board, SP3232 on board, 3V-5.5V, ESD enhanced, hardware flow control supported.

More

Resources

• Schematic
• Datasheets
• Software
• 3D Drawing

FAQ

Question:Using the RS232 Board, the sending and receiving ends are short-circuited, and there is no way to perform a loopback test using the serial port debugging?

 Answer:

VCC, GND need external power supply, 3V-5.5V.

{{{5}}}

Question:Using the RS232 Board, can the loopback test be performed but no data is received when connected to the MCU?

 Answer:

Note the following connections:

RxOUT: connect to MCU.RX (signal flow: MCU.RX << SP3232 << PC.TX )
TxIN: connect to MCU.TX (signal flow: MCU.TX >> SP3232 >> PC.RX)
Simply put, if the traditional RxOUT is connected to the TXD, and the TxIN is connected to the RXD and cannot be used, try switching it. That is, RxOUT is connected to RXD, and TxIN is connected to TXD.

{{{5}}}

Beware of knock-offs

Please note that we've found some poor copies of this item in the market. They are usually made of inferior materials and shipped without any testing.

You might be wondering if the one you're watching or you've purchased in other non-official stores is original, feel free to contact us.

Support

If you require technical support, please go to the Support page and open a ticket.