RPi IR-CUT Camera
From Waveshare Wiki
Revision as of 13:45, 7 March 2019 by Waveshare-admin (talk | contribs) (Text replace - "Cameras Raspberry Pi Raspberry Pi Camera" to "Modules Cameras Raspberry Pi [[Category:Rasp)
| ||
Introduction
Resources
FAQ
Answer:
RPi IR-CUT Camera works on Normal Mode by default. There are two ways to toggle between Normal Mode and Night-vision Mode.
1. By editing the config.txt file:
sudo nano /boot/config.txt
and append:
disable_camera_led=1
exit with save and restart your Pi then the camera will work on Night-vision Mode.
To revert to the Normal Mode, please remove the line disable_camera_led=1 then save and restart your Pi.
2. By changing the level on this position:
Thus, you can connect the GPIO from your Pi to this position, and toggle modes by changing the GPIO logic level. (HIGH --> Normal Mode, LOW --> Night-vision Mode)
{{{5}}}
Support
Support
If you require technical support, please go to the Support page and open a ticket.