ICE Tower Fan for Pi

From Waveshare Wiki
Revision as of 12:32, 28 November 2019 by Waveshare-admin (talk | contribs)
Jump to: navigation, search

How to assemble

Raspberry Pi 3B+

  • 1. Fixed the steel mounting fixer to radiator's heat dissipation cube with M2.0 screws
  • 2. Fixed the steel mounting fixer to Raspberry Pi 3B+’s mounting hole with M2.5 copper stick, and please make sure the heat dissipation is contact to CPU shield properly.
  • 3. Fixed the copper stick to Raspberry Pi with M2.5 nuts.
  • 4. Connect the red wire to GPIO 5V pin and black wire to GPIO GND pin.

Raspberry Pi 4B

  • 1. Fixed the steel mounting fixer to radiator's heat dissipation cube with M2.0 screws
  • 2. Fixed the steel mounting fixer to Raspberry Pi 4B’s mounting hole with M2.5 copper stick, and please make sure the heat dissipation is contact to CPU shield properly.
  • 3. Fixed the copper stick to Raspberry Pi with M2.5 nuts.
  • 4. Connect the red wire to GPIO 5V pin and black wire to GPIO GND pin.

Package Include

  • 1 x Ice Tower radiator and Fan
  • 2 x Steel Mounting brackets
  • 8 x M2.5x6 Copper sticks
  • 4 x M2.5 Nuts
  • 6 x M2.5x4 screws
  • 3 x Thermal Tape
  • 1 x Screw Driver
  • 1 x Protective Acrylic Panel


PS: Product does not contain thermal silicone grease, but if you have thermal silicone the dispassion effect will be better.

Customer Review

FAQ

  • Q: Can it be install to my retroflag case?
 A: No, the dimension is too big. 
  • Q: How many degrees can be decreased ?
 A: We've tested it at room temperature 25℃, it can decreased about 40℃.
  • Q: Does it easy to assemble?
 A: Yes, it is very easy to install, we've provided an instruction for you.