Difference between revisions of "ETH/USB HUB HAT"
From Waveshare Wiki
| Line 35: | Line 35: | ||
*[https://www.waveshare.com/w/upload/7/7f/ETH-USB-HUB-BOX-Assembly.jpg ETH-USB-HUB-BOX Assembly] | *[https://www.waveshare.com/w/upload/7/7f/ETH-USB-HUB-BOX-Assembly.jpg ETH-USB-HUB-BOX Assembly] | ||
*[https://www.waveshare.com/w/upload/3/3e/ETH_USB_HUB_HAT_3D_Drawing.zip ETH/USB HUB HAT 3D Drawing] | *[https://www.waveshare.com/w/upload/3/3e/ETH_USB_HUB_HAT_3D_Drawing.zip ETH/USB HUB HAT 3D Drawing] | ||
| + | ==FAQ== | ||
| + | {{FAQ|The Raspberry Pi does not recognize the usb device| | ||
| + | Connect the USB HUT interface to the computer with a USB cable to see if the computer can recognize the USB HUB. If the module can be recognized it should work fine. Check the usb connector for poor contact. | ||
| + | In addition, if the USB port of the Raspberry Pi ZERO is set to a wired network card, the USB HUB will not be recognized. |||}} | ||
| + | {{FAQ|CM4 does not recognize the usb device | ||
| + | |The USB2.0 of the CM4 is disabled by default. If you need to open it, you can add it in config.txt | ||
| + | <pre>dtoverlay=dwc2,dr_mode host</pre> | ||
| + | |||}} | ||
==Supports== | ==Supports== | ||
{{Service00}} | {{Service00}} | ||
Revision as of 02:43, 30 March 2022
| ||
| ||
Instructions
Ethernet / USB HUB HAT for Raspberry Pi, 1x RJ45 Ethernet Port, 3x USB Ports
How to use it
- Insert the ETH/USB HUB HAT to Raspberry Pi. Connect USB interface of Raspberry Pi to micro USB interface of ETH/USB HUB HAT
- Connect Network cable to RJ45 interface of ETH/USB HUB HAT
- Power on Raspberry Pi. PWR indicator lights on and ACT indicator is flashing. Now you can check the network and USB ports
- When USB devices are connected to USB1~USB3 ports, related LED D1-D3 light on
Interfaces
| SYMBOL | Description |
|---|---|
| USB | USB interface, should be connected to USB port of Raspberry Pi |
| USB1~USB3 | Extended USB ports, can be connected to external USB devices |
| ETH | RJ45 port, can be connect to wired network |
Resources
FAQ
Answer:
Connect the USB HUT interface to the computer with a USB cable to see if the computer can recognize the USB HUB. If the module can be recognized it should work fine. Check the usb connector for poor contact.
In addition, if the USB port of the Raspberry Pi ZERO is set to a wired network card, the USB HUB will not be recognized.
Answer:
The USB2.0 of the CM4 is disabled by default. If you need to open it, you can add it in config.txt
dtoverlay=dwc2,dr_mode host
Supports
Support
If you require technical support, please go to the Support page and open a ticket.