Difference between revisions of "E-Paper ESP32 Driver Board"
From Waveshare Wiki
Line 36: | Line 36: | ||
* Set the model: Set the No. 1 switch according to the E-Paper model you are using. There are many models of the E-Paper. If the model you used is not listed, please use ‘A’ first to try. | * Set the model: Set the No. 1 switch according to the E-Paper model you are using. There are many models of the E-Paper. If the model you used is not listed, please use ‘A’ first to try. | ||
[[File:ESP32_SWITCH.png|900px]] | [[File:ESP32_SWITCH.png|900px]] | ||
− | | | + | |
+ | *Turn on the serial port module: Turn the No. 2 switch to "ON", this switch controls the power supply of the CP2102 (USB to UART module). When you don’t need to use it, you can manually turn off the module to save power (if the No. 2 switch is in the OFF state, the device cannot upload the program) | ||
+ | [[File:Epd_esp32_hard_3.png|600px]] | ||
+ | ||}} | ||
==Support== | ==Support== | ||
{{Service00}} | {{Service00}} |
Revision as of 02:15, 1 April 2021
| ||
Introduction
Universal e-Paper Driver HAT, Onboard ESP32, supports various Waveshare SPI interface e-Paper raw panels. Supports refreshing image to e-paper via WIFI or Bluetooth
More |
Resources
Documentation
Demo Code
Related Resources
This is a post in Arduino Form about our SPI e-Paper thanks to ZinggJM, maybe you want to refer to.
FAQ
Answer:
- Set the model: Set the No. 1 switch according to the E-Paper model you are using. There are many models of the E-Paper. If the model you used is not listed, please use ‘A’ first to try.
- Turn on the serial port module: Turn the No. 2 switch to "ON", this switch controls the power supply of the CP2102 (USB to UART module). When you don’t need to use it, you can manually turn off the module to save power (if the No. 2 switch is in the OFF state, the device cannot upload the program)
{{{5}}}
Support
Support
If you require technical support, please go to the Support page and open a ticket.