Difference between revisions of "Color Sensor"
From Waveshare Wiki
(→FAQ) |
|||
| Line 3: | Line 3: | ||
==Resources== | ==Resources== | ||
| − | + | [[File:Color-Sensor_l.jpg|thumb|right|300px |alt=Color-Sensor|link=http://www.waveshare.com/Color-Sensor.htm | Color Sensor]] | |
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
*[http://www.waveshare.com/Color-Sensor.htm Introduction] | *[http://www.waveshare.com/Color-Sensor.htm Introduction] | ||
Revision as of 02:10, 9 May 2015
[中文]
Resources
FAQ
Why the color data from the color sensor is different from the actual color?
After powered up, the color sensor should have a white balance adjustment before use. Connect the sensor to a development board, and download the corresponding Demo to the development board. Then, place a white object at the top of the sensor in a distance of 1cm and power up the development board. The white balance adjustment will take 3 seconds. When finished, the sensor is ready for color detection. Placing an object to be measured at the front side of the sensor, you will get the actual color of this object.
Support
Support
If you require technical support, please go to the Support page and open a ticket.