Difference between revisions of "Barcode Scanner Module (B)"
From Waveshare Wiki
| Line 21: | Line 21: | ||
==Resource== | ==Resource== | ||
===Document=== | ===Document=== | ||
| − | *[https://www.waveshare.com/w/upload/7/74/Barcode_Scanner_Module_%28B%29_Setup_Manual-EN.pdf Barcode Scanner Module (B) Setup Manual | + | *[https://www.waveshare.com/w/upload/7/74/Barcode_Scanner_Module_%28B%29_Setup_Manual-EN.pdf Barcode Scanner Module (B) Setup Manual] |
===Software=== | ===Software=== | ||
*[https://www.waveshare.com/w/upload/7/7a/RM500U-CN-sscom.zip SSCOM Serial Assistant] | *[https://www.waveshare.com/w/upload/7/7a/RM500U-CN-sscom.zip SSCOM Serial Assistant] | ||
{{service00}} | {{service00}} | ||
Revision as of 13:49, 10 March 2023
| ||
Overview
Introduction
The Barcode Scanner Module (B) is a Barcode/QR codes scanner module, by using the intelligent image recognition algorithm, it can decode the 1D or 2D code on paper or screen fastly and accurately. Supports a variety of barcode formats and 4mil high-density barcode scanning. Onboard USB and UART interfaces, can be directly plugged into a computer, or be easily integrated into kinds of embedded devices.
Quick Test
The default factory setting of the Barcode Scanner Module (B) is USB keyboard mode and key scanning.
- Connect the USB interface of the device to the computer via the USB cable.
- Open a document editor (word or notebook) and click on the document to keep typing.
- Press the button to turn on scanning and scan any barcode. (note that the relevant setting code in the setting manual will not output results and cannot be used for testing.)
- Normally, the scan result will be printed automatically, and the buzzer will sound to indicate that the decoding is successful.
For more setting functions, please check the setup manual in the documentation.
Resource
Document
Software
Support
If you require technical support, please go to the Support page and open a ticket.