A7600X RNDIS Dail-up Networking

• Connect the A7600X 4G HAT to the Raspberry Pi or Jetson Nano via the USB port, and then execute the following commands to check whether ttyUSB1 can be recognized normally, if it is successfully recognized, open the port through minicom

ls /dev/ttyUSB*
sudo minicom -D /dev/ttyUSB1

• Send the following commands through minicom and wait for the module to restart

AT+DIALMODE=0
AT$MYCONFIG="usbnetmode",0

• Run the ifconfig command to see if a USB0 card is identified

ifconfig

• Get IP address

sudo dhclient -v usb0

• And then you can test whether the device can connect the internet normally through usb0 port.

Such as testing a website:

ping -I usb0 www.baidu.com

700px

• If it still can't connect to the Internet, you can set the dns as follows:

sudo route add -net 0.0.0.0 usb0