Difference between revisions of "7inch LCD for Pi"

From Waveshare Wiki
Jump to: navigation, search
Line 27: Line 27:
 
== How to use ==
 
== How to use ==
 
[[File:7inch-LCD-for-Pi-Manual01.png|400px|thumb|Hardware connection]]
 
[[File:7inch-LCD-for-Pi-Manual01.png|400px|thumb|Hardware connection]]
* 1. Write the Raspbian, Ubuntu Mate, or OSMC system image to your micro SD card. You can download the images from Raspberry Pi web site https://www.raspberrypi.org/downloads/  
+
* 1. Write the Raspbian, Ubuntu Mate, or OSMC system image to your micro SD card (''not support any system installed from NOOBS''). You can download the images from Raspberry Pi web site https://www.raspberrypi.org/downloads/  
 
* 2. Edit the /boot/config.txt file in the SD card and append the following lines:
 
* 2. Edit the /boot/config.txt file in the SD card and append the following lines:
 
  dtoverlay=dpi24
 
  dtoverlay=dpi24

Revision as of 03:19, 6 July 2017

7inch LCD for Pi
7inch IPS Display for Raspberry Pi, DPI interface, no Touch, 1024x600
7inch-LCD-for-Pi-1.jpg

1024x600, 7inch IPS Display for Raspberry Pi, DPI interface, no Touch
{{{name2}}}

{{{name3}}}

{{{name4}}}

{{{name5}}}

Introduction

1024x600, 7inch IPS Display for Raspberry Pi, DPI interface, no Touch

More

Features

  • 1024x600 high resolution
  • Compatible with Raspberry Pi 2B/3B/Zero/Zero W
  • The TFT LCD is directly driven by Raspberry Pi DPI interface, refresh rate up to 60Hz
  • Supports Raspbian, Ubuntu, OSMC, etc.
  • Back light control to lower power consumption
  • Compact size, suit for various projects

How to use

Hardware connection
  • 1. Write the Raspbian, Ubuntu Mate, or OSMC system image to your micro SD card (not support any system installed from NOOBS). You can download the images from Raspberry Pi web site https://www.raspberrypi.org/downloads/
  • 2. Edit the /boot/config.txt file in the SD card and append the following lines:
dtoverlay=dpi24
enable_dpi_lcd=1
display_default_lcd=1
dpi_group=2
dpi_mode=87
dpi_output_format=0x6f005
hdmi_cvt 1024 600 60 6 0 0 0

You must make sure that there are no spaces on either side of the equal sign.

  • 3. Save the file and insert the SD card into your Pi.
  • 4. Turn on the backlight switch.
  • 5. Power up and the LCD will display in most cases.
  • Note: RGB LCD HAT is designed for many LCD types, and the VCOM voltage can be changed by fine tuning the VCOM adjustable resistor to get a proper image. Each LCD may has a slightly different VCOM voltage, in some cases, you have to adjust it to get a better image. Besides, VCOM voltage cannot exceed a certain range. Long working out of the VCOM voltage range may lead to LCD damages, so please don't make the LCD work in abnormal status more than 10 secs while adjusting the resistor.
7inch-lcd-for-pi-manual02.png

Resources

Documentation

Software

General Tutorial Series

Support

Support

If you require technical support, please go to the Support page and open a ticket.