Difference between revisions of "4inch RPi LCD (A)"
| Line 4: | Line 4: | ||
==Resources== | ==Resources== | ||
[[File:4inch-RPi-LCD-A_l.jpg|thumb|right|300px |alt=4inch-RPi-LCD-A|link=http://www.waveshare.com/4inch-RPi-LCD-A.htm | 4inch RPi LCD (A)]] | [[File:4inch-RPi-LCD-A_l.jpg|thumb|right|300px |alt=4inch-RPi-LCD-A|link=http://www.waveshare.com/4inch-RPi-LCD-A.htm | 4inch RPi LCD (A)]] | ||
| − | + | {{Resource list| | |
*[http://www.waveshare.com/4inch-RPi-LCD-A.htm Introduction] | *[http://www.waveshare.com/4inch-RPi-LCD-A.htm Introduction] | ||
*[http://www.waveshare.com/w/upload/3/3e/RPi-LCD-User-Manual.pdf User manual] | *[http://www.waveshare.com/w/upload/3/3e/RPi-LCD-User-Manual.pdf User manual] | ||
| Line 10: | Line 10: | ||
*[[RPi_Software|Software]] | *[[RPi_Software|Software]] | ||
*[[4inchRPI_IMAGE|Image]] | *[[4inchRPI_IMAGE|Image]] | ||
| − | + | }} | |
==FAQ== | ==FAQ== | ||
Revision as of 10:06, 13 July 2015
[中文]
Resources
FAQ
Firstly, you should make sure the custom mirror image used can boot to desktop. Run the following command:
sudo raspi-config
Check the configuration: Enable Boot to Desktop/Scratch -> Desktop Log in as user ‘pi’ at the graphical desktop
Download RPi LCD driver and unzip it. Copy the file LCD-show.tar.gz into your custom mirror image via the network or an U disk. Run the following command:
tar xvf LCD-show.tar.gz cd LCD-show/
- For 3.2inch RPi LCD (B), run the command:
sudo ./LCD32-show
- For 3.5inch RPi LCD (A), run the command:
sudo ./LCD35-show
- For 4inch RPi LCD (A), run the command:
sudo ./LCD4-show
- For 5inch HDMI LCD, run the command:
sudo ./LCD5-show
Then, wait a few minutes, the system will restart automatically. When finished, the RPi LCD is ready to use.
To switch to HDMI display, run the command:
sudo ./LCD-hdmi
{{{5}}}
You should update the mirror image in the same manner as the method shown below, otherwise the system mirror image may not run after updated:
sudo apt-mark hold raspberrypi-bootloader sudo apt-get update sudo apt-get upgrade
{{{5}}}
Support
Support
If you require technical support, please go to the Support page and open a ticket.