Difference between revisions of "4.3inch HDMI LCD"
Line 18: | Line 18: | ||
{{Amazon|{{#urlget:amazon|default}}=display | {{Amazon|{{#urlget:amazon|default}}=display | ||
|More = [http://www.waveshare.com/4.3inch-HDMI-LCD.htm More]}} | |More = [http://www.waveshare.com/4.3inch-HDMI-LCD.htm More]}} | ||
+ | ==Revisions== | ||
+ | We update the controller of 4.3inch HDMI LCD from TFP401A to RTD2660H because of supply reasons. RTD2660H has higher compatibility than TFP401A, however, higher the consumption. Please check the version of the LCD you received. | ||
+ | |||
+ | V1: | ||
+ | |||
+ | [[File:4.3inch_HDMI_LCD_10.jpg|500px]] | ||
+ | |||
+ | V2: | ||
+ | |||
+ | [[File:4.3inch_HDMI_LCD_11.jpg|500px]] | ||
+ | |||
<!--{{4.3inch HDMI LCD Manual}}--> | <!--{{4.3inch HDMI LCD Manual}}--> | ||
== Resource == | == Resource == |
Revision as of 11:08, 17 May 2019
| ||
Introduction
4.3inch Resistive Touch Screen LCD, HDMI interface, Designed for Raspberry Pi
More |
Revisions
We update the controller of 4.3inch HDMI LCD from TFP401A to RTD2660H because of supply reasons. RTD2660H has higher compatibility than TFP401A, however, higher the consumption. Please check the version of the LCD you received.
V1:
V2:
Resource
User Manual
Driver
The driver can be downloaded from github
git clone https://github.com/waveshare/LCD-show.git
Software
Image
Description: if you felt hard to install driver, try the image with driver pre-installed.
LCD Panel Dimension
FAQ
{{{5}}}
- Make sure the hardware connection is correct and the contact is good.
- Make sure that TF card programming is normal.
- When the Raspberry Pi starts normally, the PWR light is always on, and the ACT light is flashing. If it is found that both lights are always on, it may be that the TF card is not successfully programmed to the image or the TF card is in poor contact with the Raspberry Pi.
- It is recommended to use a 5V 2.5A power adapter for the Raspberry Pi. If the Raspberry Pi is powered by the USB port of the PC, the Raspberry Pi may not be able to start normally due to an insufficient power supply.
{{{5}}}
{{{5}}}
{{{5}}}
{{{5}}}
Anti-Piracy
Since the first-generation Raspberry Pi released, Waveshare has been working on designing, developing, and producing various fantastic touch LCDs for the Pi. Unfortunately, there are quite a few pirated/knock-off products in the market. They're usually some poor copies of our early hardware revisions, and comes with none support service.
To avoid becoming a victim of pirated products, please pay attention to the following features when purchasing:
Support
Support
If you require technical support, please go to the Support page and open a ticket.