Difference between revisions of "3.2inch RPi LCD (B)"

From Waveshare Wiki
Jump to: navigation, search
Line 8: Line 8:
*[[RPi_LCD_ApplicationNotes|Application notes]]
*[[RPi_LCD_ApplicationNotes|Application notes]]

Revision as of 09:33, 2 July 2015



3.2inch RPi LCD (B)


How to apply the RPi LCD in a custom Raspbian system mirror image?

Firstly, you should make sure the custom mirror image used can boot to desktop. Run the following command:

sudo raspi-config 

Check the configuration: Enable Boot to Desktop/Scratch -> Desktop Log in as user ‘pi’ at the graphical desktop

Download RPi LCD driver and unzip it. Copy the file LCD-show.tar.gz into your custom mirror image via the network or an U disk. Run the following command:

tar xvf LCD-show.tar.gz
cd LCD-show/
  • For 3.2inch RPi LCD (B), run the command:
sudo ./LCD32-show
  • For 3.5inch RPi LCD (A), run the command:
sudo ./LCD35-show
  • For 4inch RPi LCD (A), run the command:
sudo ./LCD4-show
  • For 5inch HDMI LCD, run the command:
sudo ./LCD5-show

Then, wait a few minutes, the system will restart automatically. When finished, the RPi LCD is ready to use.

To switch to HDMI display, run the command:

sudo ./LCD-hdmi

The system mirror image cannot run after updated. Why?

You should update the mirror image in the same manner as the method shown below, otherwise the system mirror image may not run after updated:

sudo apt-mark hold raspberrypi-bootloader
sudo apt-get update
sudo apt-get upgrade


Please contact us by Email/Skype/WeChat for technology support.Our response may be delay, you can just leave your questions, we will reply to you as soon as possible in working time.

Service email.png [email protected]
Service skype.png [email protected]
Service wechat.png Webchat Linzeru.png
Service time.png 09:00 - 18:00 (UTC+8 Monday to Staturday)