Difference between revisions of "10.1inch HDMI LCD"
(→Driver) |
|||
Line 34: | Line 34: | ||
== Resource == | == Resource == | ||
=== Driver === | === Driver === | ||
− | {{ | + | {{10.1inch HDMI LCD DRIVER}} |
+ | |||
=== LCD Panel Dimension === | === LCD Panel Dimension === | ||
* [http://www.waveshare.com/w/upload/e/e6/10.1inch-hdmi-lcd-panel-dimension.pdf 10.1inch HDMI LCD panel dimension] | * [http://www.waveshare.com/w/upload/e/e6/10.1inch-hdmi-lcd-panel-dimension.pdf 10.1inch HDMI LCD panel dimension] |
Revision as of 08:53, 15 January 2018
| ||
Introduction
10.1inch Resistive Touch Screen LCD, HDMI interface, Designed for Raspberry Pi
More |
About LCD Version
Since from December 2017, The display of 10.1inch HDMI LCD has been updated to RTD2660 instead of TFP401.
The new version improves the compatibility with various device. New version has 5 Keys on the backside, user could use them to change the brightness and contrast ratio of LCD.
New RTD2660 version could replace the old TFP401 version in most situation. If you want the old version, please kindly contact us. To differentiate these two version, you can refer to the pictures below, the left is the new on, RTD2660 version, and the right is TFP401 version.
User Manual
- 10.1inch HDMI LCD (Old TFP401 Version) User Manual
- 10.1inch HDMI LCD (New RTD2660 Version) User Manual
Resource
Driver
If the touch screen doesn't work properly, please install the driver: LCD-show-171219.tar.gz, but not LCD-show-161112.tar.gz.
LCD Panel Dimension
Software
Image
Description: if you felt hard to install driver, try the image with driver pre-installed.
LCD Panel Dimension
FAQ
{{{5}}}
- Make sure the hardware connection is correct and the contact is good.
- Make sure that TF card programming is normal.
- When the Raspberry Pi starts normally, the PWR light is always on, and the ACT light is flashing. If it is found that both lights are always on, it may be that the TF card is not successfully programmed to the image or the TF card is in poor contact with the Raspberry Pi.
- It is recommended to use a 5V 2.5A power adapter for the Raspberry Pi. If the Raspberry Pi is powered by the USB port of the PC, the Raspberry Pi may not be able to start normally due to an insufficient power supply.
{{{5}}}
{{{5}}}
{{{5}}}
{{{5}}}
Anti-Piracy
Since the first-generation Raspberry Pi released, Waveshare has been working on designing, developing, and producing various fantastic touch LCDs for the Pi. Unfortunately, there are quite a few pirated/knock-off products in the market. They're usually some poor copies of our early hardware revisions, and comes with none support service.
To avoid becoming a victim of pirated products, please pay attention to the following features when purchasing:
Support
Support
If you require technical support, please go to the Support page and open a ticket.