Difference between revisions of "0.95inch RGB OLED (B)"
From Waveshare Wiki
Line 1: | Line 1: | ||
[[Category:OLEDs / LCDs| ]][[Category:OLED| ]] | [[Category:OLEDs / LCDs| ]][[Category:OLED| ]] | ||
[[http://www.waveshare.net/wiki/0.95inch_RGB_OLED_(A) 中文]] | [[http://www.waveshare.net/wiki/0.95inch_RGB_OLED_(A) 中文]] | ||
+ | [[File:0.95inch-RGB-OLED-B_l.jpg|thumb|right|300px |alt=0.95inch-RGB-OLED-B|link=http://www.waveshare.com/0.95inch-RGB-OLED-B.htm | 0.95inch RGB OLED (B)]] | ||
+ | == Introduction == | ||
+ | 0.95inch RGB OLED, SPI interface, straight/vertical pinheader | ||
+ | [http://www.waveshare.com/0.95inch-RGB-OLED-B.htm More] | ||
==Resources== | ==Resources== | ||
− | |||
− | |||
− | |||
*[[:File:0.95inch-RGB-OLED-UserManual.pdf|User Manual]] | *[[:File:0.95inch-RGB-OLED-UserManual.pdf|User Manual]] | ||
*[[:File:0.95inch-RGB-OLED-Schematic.pdf|Schematic]] | *[[:File:0.95inch-RGB-OLED-Schematic.pdf|Schematic]] |
Revision as of 09:29, 16 November 2015
[中文]
Introduction
0.95inch RGB OLED, SPI interface, straight/vertical pinheader
Resources
FAQ
Answer:
The OLED module is used in a 3.3V system by default.
{{{5}}}
Answer:
Under normal working conditions, generally 50,000 hours.
{{{5}}}
Answer:
At the operating voltage of 3.3V:
Working current of 0.95inch RGB OLED: about 38mA for full white display, about 4mA for full black display.
The working current of 0.96inch OLED is about 25mA when fully on, and 1.5mA when fully off.
{{{5}}}
Answer:
OLED has no backlight, and the display is self-illuminating. Only connect VCC and GND, the OLED will not light up.
Program control is required to brighten the OLED.
Program control is required to brighten the OLED.
{{{5}}}
Answer:
1. Be careful not to connect the power supply in reverse.
2. The same picture cannot be displayed for a long time, otherwise it will produce afterimages and cause damage to the OLED.
2. The same picture cannot be displayed for a long time, otherwise it will produce afterimages and cause damage to the OLED.
{{{5}}}
Support
Support
If you require technical support, please go to the Support page and open a ticket.