0.95inch RGB OLED (A)
From Waveshare Wiki
| ||
Introduction
0.95inch RGB OLED, SPI interface, curved/horizontal pinheader
Pinout
PIN | Description |
VCC | 3.3V/5V Power input |
GND | Ground |
DIN | Data input |
SCL | Clock input |
CS | Chip select, active low |
DC | Data/command signal selection, low level indicates command, high level indicates data |
RST | Reset signal, active low |
PS: This module only has SPI interface, please pay attention when using it
Resources
FAQ
Answer:
The OLED module is used in a 3.3V system by default.
{{{5}}}
Answer:
Under normal working conditions, generally 50,000 hours.
{{{5}}}
Answer:
At the operating voltage of 3.3V:
Working current of 0.95inch RGB OLED: about 38mA for full white display, about 4mA for full black display.
The working current of 0.96inch OLED is about 25mA when fully on, and 1.5mA when fully off.
{{{5}}}
Answer:
OLED has no backlight, and the display is self-illuminating. Only connect VCC and GND, the OLED will not light up.
Program control is required to brighten the OLED.
Program control is required to brighten the OLED.
{{{5}}}
Answer:
1. Be careful not to connect the power supply in reverse.
2. The same picture cannot be displayed for a long time, otherwise it will produce afterimages and cause damage to the OLED.
2. The same picture cannot be displayed for a long time, otherwise it will produce afterimages and cause damage to the OLED.
{{{5}}}
Support
If you require technical support, please go to the Support page and open a ticket.