0.95inch RGB OLED (A)
0.95inch RGB OLED, SPI interface, curved/horizontal pinheader
|VCC||3.3V/5V Power input|
|CS||Chip select, active low|
|DC||Data/command signal selection, low level indicates command, high level indicates data|
|RST||Reset signal, active low|
PS: This module only has SPI interface, please pay attention when using it
Working current of 0.95inch RGB OLED: about 38mA for full white display, about 4mA for full black display.
The working current of 0.96inch OLED is about 25mA when fully on, and 1.5mA when fully off.
Program control is required to brighten the OLED.
2. The same picture cannot be displayed for a long time, otherwise it will produce afterimages and cause damage to the OLED.
If you require technical support, please go to the Support page and open a ticket.