Difference between revisions of "0.95inch RGB OLED (A)"
From Waveshare Wiki
Line 17: | Line 17: | ||
0.95inch RGB OLED, SPI interface, curved/horizontal pinheader | 0.95inch RGB OLED, SPI interface, curved/horizontal pinheader | ||
− | { | + | ==Pinout== |
− | | | + | {|border=1; style="width:700px;text-align:center" align="center"; |
+ | |-style="background:#0000ff; color:white;" align="center" | ||
+ | |PIN||Description | ||
+ | |- | ||
+ | |VCC||3.3V/5V Power input | ||
+ | |- | ||
+ | |GND||Ground | ||
+ | |- | ||
+ | |DIN||Data input | ||
+ | |- | ||
+ | |SCL||Clock input | ||
+ | |- | ||
+ | |CS||Chip select, active low | ||
+ | |- | ||
+ | |DC||Data/command signal selection, low level indicates command, high level indicates data | ||
+ | |- | ||
+ | |RST||Reset signal, active low | ||
+ | |} | ||
+ | '''PS: This module only has SPI interface, please pay attention when using it''' | ||
+ | |||
==Resources== | ==Resources== | ||
*[[:File:0.95inch-RGB-OLED-UserManual.pdf|User Manual]] | *[[:File:0.95inch-RGB-OLED-UserManual.pdf|User Manual]] |
Revision as of 06:25, 7 June 2022
| ||
Introduction
0.95inch RGB OLED, SPI interface, curved/horizontal pinheader
Pinout
PIN | Description |
VCC | 3.3V/5V Power input |
GND | Ground |
DIN | Data input |
SCL | Clock input |
CS | Chip select, active low |
DC | Data/command signal selection, low level indicates command, high level indicates data |
RST | Reset signal, active low |
PS: This module only has SPI interface, please pay attention when using it
Resources
FAQ
Answer:
The OLED module is used in a 3.3V system by default.
{{{5}}}
Answer:
Under normal working conditions, generally 50,000 hours.
{{{5}}}
Answer:
At the operating voltage of 3.3V:
Working current of 0.95inch RGB OLED: about 38mA for full white display, about 4mA for full black display.
The working current of 0.96inch OLED is about 25mA when fully on, and 1.5mA when fully off.
{{{5}}}
Answer:
OLED has no backlight, and the display is self-illuminating. Only connect VCC and GND, the OLED will not light up.
Program control is required to brighten the OLED.
Program control is required to brighten the OLED.
{{{5}}}
Answer:
1. Be careful not to connect the power supply in reverse.
2. The same picture cannot be displayed for a long time, otherwise it will produce afterimages and cause damage to the OLED.
2. The same picture cannot be displayed for a long time, otherwise it will produce afterimages and cause damage to the OLED.
{{{5}}}
Support
If you require technical support, please go to the Support page and open a ticket.