Difference between revisions of "0.95inch RGB OLED (A)"
From Waveshare Wiki
m (Text replace - "|website_cn=" to "|default=display |website_cn=") |
|||
(3 intermediate revisions by 3 users not shown) | |||
Line 22: | Line 22: | ||
*[[:File:0.95inch-RGB-OLED-UserManual.pdf|User Manual]] | *[[:File:0.95inch-RGB-OLED-UserManual.pdf|User Manual]] | ||
*[[:File:0.95inch-RGB-OLED-Schematic.pdf|Schematic]] | *[[:File:0.95inch-RGB-OLED-Schematic.pdf|Schematic]] | ||
− | *[[:File:0.95inch-RGB-OLED-Code. | + | *[[:File:0.95inch-RGB-OLED-Size.jpg|Dimensions]] |
+ | *[[:File:0.95inch-RGB-OLED-Code.zip|Code]] | ||
+ | *[[:File:0.95inch_RGB_OLED_ds.pdf|0.95inch RGB OLED Datasheet]] | ||
*[[OLED_Datasheets|Datasheets]] | *[[OLED_Datasheets|Datasheets]] | ||
Revision as of 07:15, 3 August 2017
| ||
Introduction
0.95inch RGB OLED, SPI interface, curved/horizontal pinheader
More |
Resources
FAQ
Answer:
The OLED module is used in a 3.3V system by default.
{{{5}}}
Answer:
Under normal working conditions, generally 50,000 hours.
{{{5}}}
Answer:
At the operating voltage of 3.3V:
Working current of 0.95inch RGB OLED: about 38mA for full white display, about 4mA for full black display.
The working current of 0.96inch OLED is about 25mA when fully on, and 1.5mA when fully off.
{{{5}}}
Answer:
OLED has no backlight, and the display is self-illuminating. Only connect VCC and GND, the OLED will not light up.
Program control is required to brighten the OLED.
Program control is required to brighten the OLED.
{{{5}}}
Answer:
1. Be careful not to connect the power supply in reverse.
2. The same picture cannot be displayed for a long time, otherwise it will produce afterimages and cause damage to the OLED.
2. The same picture cannot be displayed for a long time, otherwise it will produce afterimages and cause damage to the OLED.
{{{5}}}
Support
Support
If you require technical support, please go to the Support page and open a ticket.