Difference between revisions of "0.95inch RGB OLED (A)"
From Waveshare Wiki
m (Text replace - ".htm More]" to ".htm More]}}") |
m (Text replace - "|website_cn=" to "|default=display |website_cn=") |
||
Line 4: | Line 4: | ||
|category=[[:Category:OLEDs / LCDs|OLEDs / LCDs]], [[:Category:OLED|OLED]] | |category=[[:Category:OLEDs / LCDs|OLEDs / LCDs]], [[:Category:OLED|OLED]] | ||
|brand=Waveshare | |brand=Waveshare | ||
+ | |{{#urlget:amazon|default}}=display | ||
|website_cn=[http://www.waveshare.net/shop/0.95inch-RGB-OLED-A.htm 官方中文站点] | |website_cn=[http://www.waveshare.net/shop/0.95inch-RGB-OLED-A.htm 官方中文站点] | ||
|website_en=[http://www.waveshare.com/0.95inch-RGB-OLED-A.htm Waveshare Website] | |website_en=[http://www.waveshare.com/0.95inch-RGB-OLED-A.htm Waveshare Website] |
Revision as of 05:10, 3 November 2016
| ||
Introduction
0.95inch RGB OLED, SPI interface, curved/horizontal pinheader
More |
Resources
FAQ
Answer:
The OLED module is used in a 3.3V system by default.
{{{5}}}
Answer:
Under normal working conditions, generally 50,000 hours.
{{{5}}}
Answer:
At the operating voltage of 3.3V:
Working current of 0.95inch RGB OLED: about 38mA for full white display, about 4mA for full black display.
The working current of 0.96inch OLED is about 25mA when fully on, and 1.5mA when fully off.
{{{5}}}
Answer:
OLED has no backlight, and the display is self-illuminating. Only connect VCC and GND, the OLED will not light up.
Program control is required to brighten the OLED.
Program control is required to brighten the OLED.
{{{5}}}
Answer:
1. Be careful not to connect the power supply in reverse.
2. The same picture cannot be displayed for a long time, otherwise it will produce afterimages and cause damage to the OLED.
2. The same picture cannot be displayed for a long time, otherwise it will produce afterimages and cause damage to the OLED.
{{{5}}}
Support
Support
If you require technical support, please go to the Support page and open a ticket.