Details
for Jetson Orin
Suitable For Jetson Orin Nano And Jetson Orin NX Kits
for reference only, please refer to the package content for detailed part list.
Designed for Jetson Orin NX / Nano with passive cooling
Exquisite manufacturing process, Fitting & Nice Looking
Easy to install to specific scenarios
* for reference only, the DIN Rail is NOT included
Step 1: Install the M2.5×9+4 standoffs at the positions shown below.
Step 2: Apply the included thermal grease evenly to the surface of the Jetson Orin module.
Step 3: Mount the Jetson Orin module onto the heatsink and secure it with the KM2.5×8 screws.
Step 4: Connect the 4PIN cable with the power button to the corresponding connector on the base board. Install the rear panel and secure it with screws.
Step 5: Use the IPEX4 to SMA cable, connect the IPEX4 end to the wireless module, then secure the SMA connector to the front panel.
Step 6: Install the bottom cover and secure it with screws.
Step 7: Install the front cover and secure it with screws.
Step 8: Install the antennas on the SMA connectors to complete the assembly.
* for reference only, please refer to the package content for detailed part list
Weight: 1.02 kg
Quick Overview
- JETSON-ORIN-CASE-C Aluminum alloy case x1
- Button with wires x1
- Rail-mount buckle x1
- Antenna rubber plug x2
- Screws pack x1
- Thermal grease x1
